www.fmiproducts.com
126417-01A
14
Installing Access Door
1. Place access door into rectangular open-
ing in front of the glass door with the
slanted side facing forward. The slanted
surface will slide underneath the flange of
the bottom face Insert tabs on side of ac-
cess door into slots on retaining brackets
(See Figure 22).
Figure 22 - Access Door for See-Thru
Applications
Access
Door
Flange on
Face Bottom
Side
Filler
Figure 23 - Removing Control Access Cover
(Face Bottom not shown for Clarity)
Figure 24 - Control Module (Face Bottom
not shown for Clarity)
Remove
Screws
Electronic
Access Cover
Backup
Battery
Remote
Receiver
Gas
Module
ON/OFF
Switch
Light
Switch
Installing Hood
1. Install hood as shown on page 12.
Locating Control Module
1. Remove Access Plate (See Figure 22).
2. Remove 2 screws on top of the electronic
access cover (See Figure 23).
3. Remove electronic access cover by gently
pulling up and out of the fireplace. There
are two switches connected to cover.
4. The control module is located on the left
as shown in Figure 24.
5. Light switch is located on the right hand
side as shown in Figure 24.
6. ON/OFF switch is located on the left hand
side as shown in Figure 24.
GLASS PEBBLE INSTALLATION
WARNING: Do not change
or substitute glass pebbles
provided with this fireplace. If
replacing, use only replacement
glass pebbles. See
Replacement
Parts
page 27.
Green glass pebbles are included with your
fireplace.
1. Place glass pebbles in a single layer
evenly on the pebble pan. Make sure not
to place any on the burner in the center
of the pebble pan.
INSTALLATION
Continued