www.fmiproducts.com
121308-01F
22
OPERATING REMOTE CONTROL
WARNING: Fireplace can
turn on suddenly. Keep away
from burner.
After lighting pilot, let pilot flame burn for about
one minute. Slide remote selector switch to
REMOTE position. You can now turn the
burner on and off with the remote.
IMPORTANT:
Do not leave selector switch in
the REMOTE or ON position when pilot is not
lit. This will drain batteries.
When any button is pushed on remote control,
the LCD display will glow blue. The blue glow
will go off after several seconds if no action is
being taken with remote.
ON/OFF
Push ON/OFF button and burners will come
on in high position (see Figure 37). A beep
from the receiver confirms the command.
Push ON/OFF button again and burners will
turn off. A beep from the receiver confirms
the command.
OPERATION
Continued
HAND-HELD
REMOTE OPERATION
BATTERIES
WARNING: Make sure your
selector switch is in OFF posi
-
tion before installing or chang
-
ing batteries in your hand-held
remote or receiver.
For installing or replacing batteries in remote
control or receiver, see
Installing Batteries in
Remote Control and Receiver
on page 19.
Low Battery - Hand-Held Remote Control
When batteries in hand-held remote control
are low, an icon will appear on display (see
Figure 35).
ON
Figure 35 - Low Battery Display
Low Battery - Remote Receiver
When batteries in receiver are low, no acous
-
tic signal will be given when ON/OFF button
is pressed. If batteries in receiver are low,
fireplace can be switched on manually by
moving remote selector switch to ON (see
Figure 32, page 20).
FAHRENHEIT/CELSIUS INDICATOR
You can set your hand-held remote control to
display the temperature in either Fahrenheit or
Celsius. With remote control off, press Thermo
-
stat button and Mode button at the same time.
This will toggle the display from °F to °C.
Figure 46 - Remote Control Display of
Flame Height Minimum and Maximum
MINIMUM
MAXIMUM
Figure 37 - Hand-Held Remote Control
ON/OFF
MODE
UP/ DOWN
Arrows
THERMOSTAT
LCD
Display
