www.fmiproducts.com
121308-01F
19
+
+
-
+
-
-
AAA
AAA
AAA
Figure 29 - Battery Install Hand-Held
Remote Control
Battery Housing
Cover
Figure 31 - Battery Install Remote
Control Receiver
Battery Housing
Cover
Cover Plate
Screws
Receiver
Figure 30 - Remote Display
INSTALLATION
Continued
INSTALLING BATTERIES IN
REMOTE CONTROL AND RECEIvER
WARNING: Make sure your
selector switch is in OFF posi
-
tion before installing or chang
-
ing batteries in your hand-held
remote or receiver.
Installing Battery into Remote
1. Remove battery housing cover from back
of hand-held remote.
2. Install 3 AAA batteries.
3. Replace battery housing cover.
When batteries are installed, the "little house"
icon with current room temperature will be dis-
played (see Figure 29). This icon will always
show in the control window as long as the
batteries have power.
Installing Battery into Remote Receiver
1. Open lower louver to gain access to
receiver.
2. Remove screws from cover plate.
3. Remove battery housing cover.
4. Install 4 AA batteries.
5. Replace battery housing cover.
6. Replace cover plate.
7. Close louver panel.
Installing Cover Plate Onto Remote Receiver
1. Locate and remove cover plate from
packaging.
2. Make sure sliding selector switch fits over
switch on receiver.
3. Attach cover plate to receiver with 2
screws as shown in Figure 31.
4. See page 23 for instructions on program-
ming remote receiver to hand-held remote
control.
Note: For hand-held remote control to
work, programming (synchronizing) re-
mote to receiver must be completed.
