www.fmiproducts.com
121308-01F
21
3. Set remote selector switch in the AUTO
position (see Figure 32).
4. Press in and turn control knob clock-
wise
to the OFF position (see
Figure 32).
5. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the
floor. If you smell gas, STOP! Follow “B”
in the safety information on page 20. If
you don’t smell gas, go to the next step.
6. Press in and turn control knob counter-
clockwise
to the PILOT position.
Press in control knob for five (5) seconds
(see Figure 32).
Note: You may be running this heater
for the first time after hooking up to gas
supply. If so, the control knob may need
to be pressed in for 30 seconds or more.
This will allow air to bleed from the gas
system.
7. With control knob pressed in, press and
release ignitor button. This will light pilot.
The pilot is attached to the rear of the front
burner. If needed, keep pressing ignitor
button until pilot lights.
Note: If pilot does not stay lit, contact a
qualified service person or gas supplier
for repairs. Until repairs are made, light
pilot with match. To light pilot with match,
see Manual Lighting Procedure.
8. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob.
• If control knob does not pop out when
released, contact a qualified service
person or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4
through 8.
ON REMOTE OFF
PRG
Control Knob
Ignitor Button
Figure 32 - Remote Selector Switch,
Control Knob and Ignitor Button
Remote Selector
Switch
OPERATION
Continued
Figure 33 - Pilot (Propane/LP)
Ignitor
Electrode
Pilot Burner
Figure 34 - Pilot (Natural)
Ignitor
Electrode
Pilot Burner
9. Slightly push in and turn control knob coun-
terclockwise
to the ON position.
10. Press the on/off key on the remote control
to turn on appliance main burner. Wait at
least 5 seconds before setting desired
flame height.
11. Select manual flame height function by
pressing MODE button on remote until
a flame is shown in lower left corner of
display. Use the UP/DOWN arrow button
to set desired flame height (see Figure
37, page 22).
12. To leave pilot lit and shut off burners only,
turn control knob clockwise
to the
PILOT position, or use remote control ON/
OFF button
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
TO TURN OFF GAS
TO APPLIANCE
1. Press on/off key on remote control and
turn control knob clockwise
to the
OFF position (see Figure 32).
2. Close equipment shutoff valve (see Figure
22, page 16).
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 7 under
Lighting
Instructions
, page 20.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow steps 9
through 11 under
Lighting Instructions
.
