29
8.5 Set to PWM conv
This function can be used to configure FTR10 and FGR12B receivers as PWM converters (hereinafter referred
to as slaves). After configuring as slaves, the SERVO/I-BUS OUT interface of the master receiver and the SENS /
I-BUS IN interface of the slave receiver can be connected through the channel extension line, to be used as an
extension receiver channel.The "servo response speed" and "start channel" of the slave receiver can be set. In
case of re-binding, the parameters of the slave receiver are invalid. The reconfiguration is required when it is
used as a slave again.
FTR10 configured as PWM converter:
1. In the slave receiver, enter the bind mode. Click the transmitter’s [ bind with a RX] to complete the binding;
2. Enter [conf.FTR10 as I-BUS to PWM conv.] . Set the servo response speed for it;
3. Set the slave's "Start channel". The start channel value is the channel output from the slave's CH1 interface. Click the
screen "+" or "-" to modify the start channel. After the settings are complete, click [Config];
4. The slow flash of the receiver indicator indicates that the configuration of the slave receiver is complete.
5. Complete the bind of the master receiver. Through the channel extension line, connect the SERVO interface of the
master receiver and SENS interface of the slave receiver to use as an extension receiver channel.
Note：After FTR10 is configured as a PWM converter, it can only be used with the main receiver for FTR10.
FGR12B configured as PWM converter:
1. On the receiver pre-configured as a PWM converter, enter the bind mode. Click the transmitter [bind with a RX] to
finish the bind;
2. Enter the [conf.FGR12B as I-BUS to PWM conv]. If the pre-configured FGR12B receiver indicator flashes twice and
turns off once, it indicates that the configuration of FGR12B as a PWM converter is successful.
3. Bind the master receiver ;
4. Set the master receiver interface protocol to I-BUS on the transmitter;
5. Use the channel extension cable to connect the interface of the main receiver [see note (1) below] and the NPA
interface of the FGR12B configured as a PWM converter.
8.4 RX protocol
Set the receiver PPM output, select i-Bus or S.Bus (For specific i-BUS settings please refer to [8.6 i-BUS Settings]).
When "RX PPM Output" is selected, it means that the receiver CH1 outputs PPM signals. When it is not selected,
by default, the receiver CH1 outputs PWM signal. When i-Bus is selected, the corresponding channel outputs i-Bus
signal. When S. Bus is selected, the corresponding channel outputs S. Bus signal.
Function Settings:
1.
Touch RX protocol in the RX setup menu.
2.
Touch RX PPM output to check or uncheck the box.
3.
When this function is checked, the receiver CH1 outputs the
PPM signal, and the other channels have no output.
Note:(1) • If the main receiver is FTR10/FGR4, connect the SERVO interface and the NPA interface of the PWM converter;
• If the main receiver is FTR4/FGR4S/FGR4P, connect the I-BUS interface and the NPA interface of the PWM
converter;
• If the main receiver is FTR8B/FTR12B/FGR12B/FTR12B, connect the NPA interface and the NPA interface of
the PWM converter.
(2) • After the FGR12B receiver is configured as a PWM converter, the code cannot bind with the transmitter, and
the firmware needs to be refreshed.