10
1. Check to make sure the receiver is installed correctly and that the receiver is powered off.
2. Press and hold both power buttons until the screen lights up.
3. Power on the receiver.
5. Operation Guidelines
Follow these guidelines to set up the transmitter and receiver.
5.1 Power On
Follow the steps below to power on:
Note
• The system is now active, be cautious to not cause damage or personal injury.
5.2 Binding
The transmitter and receiver have been pre-bound at the factory.
If you need to rebind or bind a new receiver follow the steps below:
1. Power on the transmitter, touch the function menu icon then enter the
RX setup menu.
•
If you want to change the RF standard, please select [RF standard] in [RF
setup] menu. The system default standard is AFHDS3 2-way (for more
information about RF, see [9. RF Setup].
2. Make the receiver enter bind state; (For the specific bind modes, see the
manual of different models of receivers).
3. Touch [Bind with a receiver], to enter bind mode.
4. Difference of successful bind under two specific RF standards:
• If you choose [AFHDS3 2-way], when the receiver indicator is on,
indicating a successful bind. The transmitter automatically exits
the bind interface.
• If you choose [AFHDS3 1-way], when the receiver indicator is slow
flashing, the transmitter manually exits the bind interface, and the
receiver indicator is on, indicating a successful bind.
5. Check that the transmitter, receiver and model are all working as
expected. If there are any abnormal movements, repeat the steps above.