Flymo Sabre, Оригинальное руководство пользователя

Страница: 7 / 32

Safety
1. Always charge the product indoors and store in a cool
dry place - out of the reach of children.
2. Use only the charger provided with your unit. Use of any
other charger could permanently damage the Power Pack.
3. Use the charger with standard domestic household
electrical outlets only.
4. Do not abuse the charger or charger cord.
5. Do not use the charger if the charger or charger cord
is damaged.
6. Use the charger indoors only.
7. Do not use the charger outdoors.
8. Do not charge the Power Pack or use the unit in an
explosive or corrosive environment. Avoid areas
where flammable liquids or gases are present to
avoid creating a fire or explosion.
9. Do not attempt to repair the unit including the Power Pack.
10.Do not incinerate or mutilate the Power Pack. Batteries
contain hazardous chemicals. Dispose of properly.
If not used properly this product can be dangerous! This product can cause serious injury to the operator and others, the
warnings and safety instructions must be followed to ensure reasonable safety and efficiency in using this product. The
operator is responsible for following the warning and safety instructions in this manual and on the product.
Explanation of Symbols on your product
Warning
Read the user instructions carefully to make
sure you understand all the controls and
what they do.
Power Pack
Power Pack Care
1. If over a period of time the Power Pack quickly runs
down after a full 24 hour charging period, a
replacement Power Pack is needed.
2. There will be some charge present in the Power Pack
but to ensure maximum running time, recharge your
Power Pack for 24 hours before use.
3. Permanent connection to the charger in a well
ventilated area will automatically keep your Power
Pack fully charged ready for use.
4. To prevent permanent Power Pack damage, never
store in a discharged condition.
5. Contact your local approved service
centre/dealer/distributor for a replacement Power
Pack and for safe disposal of your old Power Pack.
6. Power Pack
24 Volt 4.5 Amp/Hour "High Power"
Sealed for Life No maintenance required
• IMPORTANT
DISPOSE OF YOUR OLD POWER PACK SAFELY
DO NOT CUT OPEN, BURN OR INCINERATE.
Power Pack Replacement
Your Power Pack is non-servicable. Should your Power
Pack need to be replaced contact your local approved
service centre or dealer who will replace your old Power
Pack with a genuine Flymo replacement Power Pack.
Winter Storage
1. Fully charge for 24 hours before winter storage.
2. If you are unable to leave your Power Pack on
permanent charge, re-charge the Power Pack every 3
to 4 months for a full 24 hour charging period to top
up the Power Pack charge during winter storage.
3. Avoid extended storage without re-charge.
4. Store in a cool dry place.
Charging the Power Pack
•
IMPORTANT !
Switch charger off at the socket before connecting or
disconnecting the Power Pack to the charger
Initial Charging Procedure
•
The Power Pack should be charged for 24 hours
before use.
• Re-charge your Power Pack immediately after every
use for the full 24 hour charging period.
• The Power Pack can be left connected to the
charger permanently, with the charger switched on,
without fear of overcharging.
• The charger will automatically keep the Power Pack
topped up with charge during storage and will
ensure that the Power Pack is ready for use.
1. Use the charger indoors only.
2. Ensure the charger is not exposed to moisture. Keep
the charger and the Power Pack dry at all times. Keep
the charger well ventilated during charging.
3. Ensure the Power Pack is correctly located into the
charger .
4. Plug the charger into a suitable household electrical
wall socket and switch on.
5. The indicator lamp glows continuously during charging.
6. Full charge will be achieved in 24 hours. During
charging the charger becomes warm. This is normal
and means the charger is operating correctly.
Re-Charging Your Power Pack
1.
Re-charge the Power Pack as soon as the cutting
power of your product begins to die and slow down.
2. Avoid running the product into "deep" discharge, i.e.
avoid flattening the Power Pack completely.
3. Follow the procedure outlined in the Initial Charging
Procedure.
4. Charging the Power Pack according to these
instructions should ensure maximum Power Pack life.
Environmental Information
Husqvarna UK Ltd. are manufactured under an
Environmental Management System (ISO 14001) using,
where practical, components manufactured in the most
environmentally responsible manner, according to
company procedures, and with the potential for recycling
at the end of the products’ life.
• Packaging is recyclable and plastic components have
been labelled (where practical) for categorised recycling.
• Awareness of the environment must be considered
when disposing of ‘end-of-life’ product.
• If necessary, contact your local authority for disposal information.
BATTERY DISPOSAL
• This product contains a lead acid battery and should
not be discarded with normal household waste at the
end of its life.
• The battery should be taken to an Approved Service
Centre or your local Recycling Station.
• Do NOT dispose of battery to water.
• Lead/Acid batteries can be harmful and should be
disposed of through the recognised recycling facility in
accordance with European Regulation
• Do NOT incinerate
The symbol on the product or on its packaging indicates
that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more
detailed information about recycling of this product, please
contact your local council office, your household waste
disposal service or the shop where you purchased the product.
ENGLISH - 1