H1 user manual
Installation
Overview
Install procedure
Please read this section carefully, install and set up your flight control system according to the following process
to ensure the normal operation of the system.
1. Ensure that the modules required for installation are complete.
2. Watch the teaching video(
)：
• Watch the installation demonstration and module connection video, install the flight control system to the
helicopter and connect it correctly.
• Watch the transmitter setup tutorial, set the transmitter to airplane mode, and set the return / GPS / manual
mode switch (5 channels)
• Set the Stop/ Run (7 channels), the circle / 8 fly (8 channels) and the invert flight (9 channels).
• Watch the parameter adjustment software setting tutorial, run the parameter adjustment software, select the
corresponding COM port (not COM1), click the connection, and complete the parameter setting according to
the software guidelines and instructions.
3. Check whether the motor rotation direction, transmitter channel setting and transmitter out of control
protection (turn off the transmitter, and the software shows that the transmitter signal is lost) are set correctly.
4. Move the magnets and speakers out of the room to ensure that there is no magnetic material in the room (or
use a notebook computer to calibrate it in the open area without high-voltage wires or iron buildings outside),
and then calibrate the compass in the software.
5. Confirm that the connection of each module is reliable, and there is no error prompt on the left side of the
main interface of the software.
6. The first flight test was carried out in the open area without high-voltage lines and iron buildings. Keep away
from the crowd and do not test in the community.
7. When the helicopter is powered on and the transmitter is powered on, put the transmitter mode switch in the
GPS position, the route switch in the off position, the stop switch in the stop position, and the invert flight switch
in the normal position. At this time, the yellow light of the flight control flashes, and the blue light is always on.
In the 3D mode, move the transmitter rocker to check the movement of the servo. After completion, flip to GPS
mode to wait for satellite search. It takes 3-5 minutes for the first use to preheat the satellite search. It is
recommended to wait for a while after the green light is on to ensure good satellite signal. Finally, push both
sticks to the bottom outer corners to unlock. After the green light flashes, flip STOP switch to STAR. The
helicopter begins to accelerate and rotate. After the speed is stable, the push rocker rises.
8. Fw450l as an example, the following figure shows the installation effect:
Содержание H1-Heli
Страница 1: ...Heli User Manual Manual V2 6 2021 03...
