H1 user manual
Home Mode
The process that the helicopter automatically returns to the last recorded return point is
called return. There are three different ways to return:
Out of control return：
When the GPS signal is good, the Compass works normally, and the return point is successfully recorded (the
point of each helicopter unlocking)，If the transmitter signal is interrupted for more than 3 seconds, the
flight control system will control the helicopter to fly back to the nearest recorded return point at an altitude
of 15 meters.If the radio signal returns to normal during the return flight, the return flight will continue, but
the user can control the flight through the transmitter and cancel the return flight. This function needs to set
5-channel out of control protection in the transmitter to jump to the HOME
When the LED light flashes slowly or the GPS doesn't work, it can't HOME.
In the process of returning, the helicopter can not avoid obstacles, so it is necessary to check the
surrounding environment before taking off to avoid more than 15 meters of objects.
In the process of returning, when the helicopter rises to 15m and returns to the landing point,
the user can fine tune the landing point of the helicopter through the transmitter.
One key to return:
The one button return mode can be started through the transmitter mode switch (5 channels), and the return
process is the same as the runaway return.
When using the transmitter receiving system, the user needs to assign a switch on the transmitter as the mode
switch key (5 channels), and set it in the parameter adjustment software.
Low voltage return:
Flight control realizes low voltage return by judging battery voltage.
When the voltage is too low, the motor may not be able to output enough power. At this time, the user should
land the helicopter as soon as possible, otherwise the helicopter will fall directly, causing damage to the
helicopter or other hazards. In order to prevent unnecessary danger caused by insufficient battery voltage,
the flight control system will judge whether the current voltage is sufficient. (currently supports 3S, 4S, 6S
intelligent judgment)
If the current voltage is insufficient, the helicopter will be forced to return. Please ensure that the current
distance of the aircraft is in line with the range of the remaining power set by the helicopter. When it touches
the low battery to return, the helicopter will actively rise to 15m above the ground and turn around to fly back
to the take-off point. At this time, the transmitter can not operate the aircraft. In the second half of the descent
process, the remote control (if the signal of the remote control is normal) can control the aircraft to fine tune to
the appropriate landing point.
If you need to stop the low-voltage return, please switch the mode HOME mode, and then switch to the GPS
mode. You can manually control the helicopter to manually turn off the motor after landing. During this period,
the aircraft will not return with low-power until the aircraft is powered off.
Содержание H1-Heli
Страница 1: ...Heli User Manual Manual V2 6 2021 03...
