Fly Wing H1-Heli, Руководство пользователя

Страница: 11 / 25

H1 user manual
Transmitter settings
Transmitter Requirement:
1. The transmitter must support SBUS mode.It has at least 9 channels and own Failed-Safe function.And you
can set the out of control protection output of all channels by yourself.Otherwise, the out of control protection
function cannot be realized.
2. The working mode of your transmitter should be Airplane.
3. All channels of the transmitter should work independently, and no need to set any mixed control, including
but not limited to "pitch curve related to helicopter, throttle curve, and linkage stop switch built in the
transmitter".
4.
You need to use 5-channel three section switch as control mode switch, 7-channel two section switch to
control motor stop and start, and 8-channel three section switch as semi autonomous flight switch.If you
need to fly backward with one button, you need to set 9 channels as a 2-stage switch.
Take Futaba 14sg as an example:
1. Set 7008sb receiver to mode B (s.bus 1) and connect flight control with s.bus 1 interface of receiver.
2. Bind transmitter with receiver，build new model，select AIRPLANE,no mix
3. LINKAGE MENU---FUNCTION Set 5 channels of transmitter as 3-stage switch (SA),
Return of corresponding aircraft ---GPS mode---3Dmanual mode ； 7 channels are set as 2-stage switch
（SF），Corresponding motor disarm and arm；The 8-channel is set as a 3-stage switch (SB), corresponding to
the semi-automatic flight closing - one key to 0 figure fly - 8-figure fly；9 channels set to 2-stage switch (SC)，
Corresponding to one key normal flight and invert flight.
4. Enter fail safe mode ， Turn on the 5-channel f / s.Set the 5-channel mode switch (SA) to the return
gear,Press and hold the "RTN" key at POS for 1 second. Then return to the main interface ， Observe on
software,turn off the transmitter in the GPS position. Will the software prompt you to lose the transmitter
signal, or will the transmitter automatically jump to the RETURN，Channel 7 stays on the start position (if
channel 7 is in the STOP position after the transmitter is turned off, please set channel 7 as out of control
and stay on the start position according to the setting of channel 5).