Fluke MicroMapper Pro, Инструкция

Страница: 19 / 20

Split pairs
Section with split pair must be at least 3 m long and greater than
10% of the cable length.
Coaxial
termination
measurements
Loop resistance between 5
Ω
and 350
Ω
is considered a
termination resistance. Loop resistance below 5
Ω
is considered a
short. Loop resistance greater than 350
Ω
is not displayed. Typical
accuracy: 5%
±
1
Ω
Toner
Generates four tones compatible with most analog probes. Tones
are generated on all wire pairs and the coaxial connector.
Calibration
cycle
Factory calibration not required
Display LCD, fixed-segment, 2.19 in x 1.69 in (5.6 cm x 4.2 cm)
Input
protection
50 V dc
Battery type
and life
Tester: 6 AAA alkaline batteries, 100 hours continuous use (non-
toner modes), low battery indicator (
) on display
PRO3000 probe: 9 V alkaline
Auto shutoff
5 minutes with no key presses.
In toner mode, turns off after 1 hour.
Dimensions and
weight
Tester: 5.9 in x 2.8 in x 1.4 in (152 mm x 72 mm x 35 mm), 8.8 oz
(250 g)
Remote ID: 2.4 in x 0.9 in x 0.9 in (60 mm x 23 mm x 22 mm),
1.1 oz (30 g)
P
RO
3000 probe: 9.8 in x 1.6 in x 1.3 in (24.9 cm x 4.1 cm x 3.3 cm)
Certifications
and compliance
EN 61326-1, EN 61010
P
Conforms to relevant European Union directives.
;
Conforms to relevant Australian standards.