Fluke MicroMapper Pro, Инструкция

Страница: 13 / 20

5 For twisted pair cable, use
D
or
C
to scroll through the length
measurements for each pair. Lengths among pairs may vary up to 5%
because each pair has a different number of twists.
Checking the Wire Map
A remote identifier is required for a complete wire map test. Without a
remote identifier, opens at the far-end connector and miswires are not
detected.
To check the wire map:
1 Select the cable type in setup.
2 Connect the cable to the tester.
3 For twisted pair cable, connect a remote identifier to the far end of the
cable.
For coaxial cable, a remote identifier is optional, but the cable must not
be terminated or connected to a device.
4 Press
W
. The wire map flashes if a fault is detected.
Table 4 shows examples of wire map displays.