fluidra GRE Balance Electrolyseur Sel 101347, Инструкция по эксплуатации

Страница: 15 / 47

101452 Installation and user manual 15
E
N
G
L
IS
H
8. Checks and maintenance
99?EG ;F<82
Check the salt level (usually once or twice a
week). If the concentration is less than 4g / l, add
salt by the calculation next:
Q = (4-T) x V
Q = quantity of salt to be added in Kg
4 = salt content to be respected
T = measured salt content in the pool
V = volume of the pool in m3
99?EG @A:B?@F< =>697@8;2
Always stop the device before adding chemical
products directly to the pool. Wait for the chemical
products to dissolve before turning the salt
chlorinator on again.
Presence of hydrogen peroxide: This product
cancels the chlorine reading for approximately 3
weeks.
The sterilizer produced by your chlorinator is
compatible with most swimming-pool water
treatment products, with the exception of those
containing PHMB polymers. In all cases, stop the
chlorinator while you add products and until they
have been completely dissolved.
$?E8:>?EG2
If the filtration of the pool is maintained during the
winter months, we recommend
turning the
chlorinator off when the temperature falls
below 15°C.
- Checking chlorine level:
This material is by no means a chlorine regulator.
The chlorine level can vary significantly depending
on the temperature, attendance, chemicals
introduced into the pool water…
A regular control of chlorine in the pool water is
necessary. Adjust chlorine production if needed in
accordance with paragraph 4.
Warning:
If you later add a shelter over your pool, such as a
telescopic shelter, remember to adjust chlorine
production if necessary by reducing the power
delivered to the electrode.
-Encrusted electrode:
The electrode must have a clean appearance
without lime scale encrustations. If need be, de-
scale the electrode by placing it in a solution
containing 80% water and 20% chlorhydric acid.
Then check why the electrode got encrusted:
•
•
Setting too low potentiometer
•
•
These anomalies are indicated by the blinking
red led.
<:FE?EG 8A: =66< 9>F?EFG: I?<8:>2
Stop the chlorinator during any handling of the
filter’s valve: cleaning, rinsing, emptying...
9. Instructions for use of the
electrode
The electrode is a wear part which depends on
the following factors longevity:
F8: 6I ;F<8 2
Never operate the electrolyzer with a salt content
of less than 3.2 g / l.
$F8:> 8:B=:>F87>: FE9 M?E8:>?EG 2
Cut operation as soon as the water temperature
drops to 15 ° C.
If continuous filtration during the cold period,
remove the electrode from the vase and replace
the plug supplied for this purpose.
:88?EG;
Adjust chlorine production using the potentiometer
and according to the desired rate.
:D:>;: =6<F>?8N 2
Polarity reversal is carried out every 4 hours. To
manually reverse the polarity of the potentiometer
set the cursor to 0. Wait 2 minutes before
repositioning the button to the desired level of
production.