MAINTENANCE
/
REP
AIR
TROUBLESHOOTING
OPERA
TION
ASSEMBL
Y /
INST
ALLA
TION
SAFETY
/
SPECIFICA
TIONS
GETTING
ST
ARTED
16
15
USER CONFIGURATION MODE
General Notes for User Configuration Mode Menus
Once in configuration mode the user can then proceed thru the configuration process
menus as shown on the “configuration process map” on the following page.
The software will retain your entries as you progress through the user configuration
menus, however, there is
no automatic “save”
when exiting. Instead, you will be
shown a “save” screen to enter “yes or no” to save your entries. (See Figure 13)
Use the
Rate
button to toggle between
“yes” or “no”. Use the
Total
button to
advance to the next display. Advancing to
the next display will perform the “save”
selection you made and return the display
to normal operation mode. The last shown
screen in that mode will be displayed.
Figure 13
Configuration Process Map – User Configuration Mode
See InDesign for Graphic
Press
Total
+
Rate
for 3 Seconds to Enter
User Configuration Mode
Normal Operation Mode
Enter PIN
Incorrect
Involuntary
Exit
Correct
Reset PIN?
Volume Unit
Flowrate / Time Period
Advanced Options
Yes
No
Display Update
Rate
Low Frequency
Cutoff
Calibration
Method
Pipe
Diameter
Daughter Board
Options
Custom Volume Unit
Calibration
Method
Field Calibration
Method Entry
Rate
+
Total
Buttons
To Exit
Must Pass Thru
Field Calibration Method Entry If
Field Calibration Methods
Dispense/Display, Percent Adjust or K-Factor Entry
Were selected
Save?
Yes or No
Exit
Message
Save?
Yes or No
Exit
Message
OPERA
TION