FLIR Ariel Gen III CM-3304-11-I, Руководство пользователя и инструкция по установке

Страница: 59 / 128

53 September 4, 2017
Configuration and Operation
CM-3304/CM-3308 User and Installation Guide
9.3.1.4.4 SNMP
The SNMP screen enables the network management system to use the Simple Network Management
Protocol (SNMP) to remotely monitor and manage the camera. Select one of the following SNMP versions:
SNMP v1, SNMP v2c, or SNMP v3.
Network > SNMP Screen
To use SNMP v1
1. From the SNMP v1 section’s Enable drop-down list, select ON . The default is OFF .
2. Click Save .
To use SNMP v2c
1. From the SNMP v2c section’s Enable drop-down list, select ON . The default is OFF .
2. In the Read Community String text box, enter the community name that has read-only access to
all supported SNMP objects. The default value is public.
3. In the Write Community String text box, enter the community name that has read/write access to
all supported SNMP objects (except read-only objects). The default value is private.
4. In the Trap Community String text box, enter the community to use when sending a trap message
to the management system. The default value is public . Traps are used by the camera to send
messages to the management system for important events or status changes.
5. Click Save .
To use SNMP v3
1. From the SNMP v3 section’s Enable drop-down list, select ON . The default is OFF .
2. From the Authentication Mode drop-down list, select MD5, SHA, or NONE (default).
3. If you select MD5 or SHA , from the Privacy Mode drop-down list, select AES, DES, or NONE
(default).
4. Enter the User Name. The default is initial .
5. If you select MD5 or SHA , enter the Authentication Password in the Authentication Password text
box.
6. The Privacy Password text box is disabled.
7. Click Save .