Setup via keypad and monitor
> About the setup of VIEWCOM/E MAX+
2
2. Setup via keypad and monitor
About the setup of VIEWCOM/E MAX+
There are two possible ways to set up VIEWCOM/E MAX+:
To access the Web page of VIEWCOM/E MAX+, it is required that an IP address has been assigned via the on-site
setup.
About the monitor view
Via the monitor you can view the VIEWCOM/E MAX+ in:
• Operational mode, showing product information, detector board overview and list of events
See
Display information of VIEWCOM/E MAX+ in operational mode
• Setup mode, with the setup menu (keypad needed)
To go to the setup mode of VIEWCOM/E MAX+
1
Press the RESET button on the front panel of the VIEWCOM/E MAX+ board.
Product information (product name, serial number, version number) is shown.
2
Press the
M
key on the keypad.
3
To exit the setup mode: from the main menu, press the
Escape
key.
Location
Using
To
On site
Keypad and monitor
Initially set up the board
Remotely
PC (VIEWCOM/E MAX+ Web page)
Change the setup of an operational board
