Setup via keypad and monitor
> Setting the image and video properties
7
Setting the image and video properties
By default, the video input signal is set to NTSC. This is the video norm that applies to the video out signal of
VIEWCOM/E MAX+ also (monitor interface).
About video input selection
If the system is configured with an I/O expansion board, readdress the camera signal(s) as illustrated below.
About image quality
VIEWCOM/E MAX+ provides single camera images from the detector board, available via the VIEWCOM/E MAX+
Web pages. You can save these images on the PC. The quality of these images is configurable.
To set image and video properties
1
Select
Images
.
2
To change the quality of the single images: select
Quality
and use the
Arrow
keys.
3
To readdress the camera signal(s): select
Video Input Selection
and use the
Arrow
keys.
4
Press the
Escape
key.
Video input selection illustrated - top: default configuration & bottom: configuration with I/O expansion board
Image quality
Image size (kb)
Low
14
Medium (default)
26
High
32
Super High
46
Image quality versus size
