Flex TRINOXFLEX BME 18.0-EC + BF 140, Оригинальная инструкция по эксплуатации

Страница: 38 / 514

TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
38
Mounting the handle

Secure the auxiliary handle by the thread
in position 1 or 2.
Adjusting the belt direction

Use the screw at the far front of the sand
-
ing arm to adjust the belt direction. While
the belt is turning, adjust it so that the belt
runs centrally over the contact roller.
Changing the sanding arm

Loosen the three securing screws to
change the sanding arm.

Remove the sanding arm.

Fit a new sanding arm using the three
screws.
Operating instructions
NOTE
When it is switched off, the power tool
continues to run briefly.
Sanding/grinding

After opening the locking screw (1.) the
swivel arm can be tilted up to 140° (2.).
In this way, the belt file sander can also be
used in areas that are difficult to reach, e.g.
on the insides of pipes.

Vary the abrading performance by means
of the contact pressure. Make sure that the
contact pressure is even and not too heavy.
In the event of excessive contact pressure,
the sanding belt could slip off the roller.
Switching on and off
Short-term operation without detent

Push the switch forwards and hold.

To switch off, release the switch.