Flex TRINOXFLEX BME 18.0-EC + BF 140, Оригинальная инструкция по эксплуатации

Страница: 37 / 514

TRINOXFLEX BME 18.0-EC + LK 152 / + BR 50 / + BF 140 / + BS 50
37
Work instructions for the pipe belt sand
-
ing attachment
CAUTION!
When it is switched off, the sanding tool
continues to run briefly.
Compared with a sanding/grinding disc, the
advantages of a belt sander are as follows:
– Cool sanding
– Clean finish without scoring
– High abrading performance
– High productivity owing to large angle of
contact (depending on diameter)
Sanding/grinding:
NOTE
After bringing into contact with the work
-
piece and before switching on the machine,
check that the belt is in complete contact
with the rollers.
– Pipes are sanded between rollers 31
and 33.
– The angle of contact and the abrading
performance can be varied by the amount
of pressure applied.
– The smaller the pipe diameter, the greater
the possible angle of contact. An angle of
up to 270° is possible.
Sealing:
Many manufacturers recommended sealing
finished surfaces with a protective spray
(see Flex stainless steel accessories).
For further information on the manufactur
-
er’s products go to www.flex-tools.com.
Belt file sanding attachment BF 140
WARNING!
Remove the battery before carrying out any
work on the power tool.
Fitting or changing the sanding belt

Remove the battery.

Remove the handle (1.).

Swivel the housing cover to one side (2.).

Turn the eccentric screw and in doing so
detension the sanding belt (3.).

Remove the sanding belt (4.) (optional).

Fit a new sanding band centrally on the
sanding arm (5.).

Tension the sanding belt by turning the ec
-
centric screw.

Fold the housing cover back onto the
housing.
CAUTION!
Observe the prescribed direction of belt
rotation! The direction of rotation must
correspond with the arrow on the gear head.