37
TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Document Code
Rev.
Date saved
Date printed
T300 - T350 - T400 ISTRUZIONI
01
14/07/2016
14/07/2016
EN
$$#*#+[$$
"!#(
< "
1. Check that screw C1 is tight.
\ >]>>
3. Slacken nut E2
4. Slightly slacken screw C1
5. Slacken screw D2 by a quarter turn (max.) or as much as is
necessary.
6. Tighten nut E2
7. Tighten screw C1
\ %
>]>>\
< "
]\ >]>>
2. Slacken nut E2
3. Slightly slacken screw C1
4. Tighten screw D2 by a quarter of a turn (max.) or as much as
is necessary.
5. Activate so as to block the nut E2
6. Tighten screw C1
%
>]>>\
_*#+)%$%
"!#(
]\ >]>>
2. Slacken screw C1
3. Move the blade support forward so that the distance at the
vertex between the two blades is 1.5 - 2.0 mm.
^\ < D]>]>>\
"!<$"=$!#*#*%&$"\*#+
"!#(
< "
1. Slacken nut
A1
2. To increase the angle ("+" see drawing) slightly screw nut B1
(max. 1/8 of a turn)
To decrease the angle ("-" see drawing) slightly unscrew the nut
B1(max. 1/8 of a turn)
3. Tighten nut
A1
4. check the vertical angle (using the relative dial indicator).
Repeat the operations from step 1 to step 3 until the required
position has been achieved.
NOTE – Adjustment of the cutting angle, as described in
6 7
adjustment slots in the supports.
NOTE – Do not adjust the cutting angle by acting on the
right-hand blade: it is advisable to act always and only on
the left-hand blade.
`$!#*#*
$$#*
Blade vertex
Position of the
blade vertex
NOTE – For correct use of the blades, please follow the instructions provided by the blade manufacturer.
A3
D2
E2
A1
C1
D1
E1
A2
A1
B1
A2
