29
TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Document Code
Rev.
Date saved
Date printed
T300 - T350 - T400 ISTRUZIONI
01
14/07/2016
14/07/2016
EN
$$*$"$%)
The machine has two stops which slide along the entire length of the aluminium guide.
<! ! !
short sides.
There are two different kinds of stop:
#$"!$$*$"
< ! !
top and along the entire length of the extension to the right of the
] ^ !
make it possible to size the INTERNAL (2) length of the frame to
\
% ! ^
set the cutting length measurement by matching this internal edge
with the relative etched line indicating the required distance from
the blade.
Mobile stop (A):
this is the one located closest to the blades and establishes the
length of the shorter frame side.
Fixed stop (B):
This cannot be lifted out of the way like the mobile stop and is
used to establish the length of the longer frame side.
The correct combination of the two stop lengths makes it possible to switch quickly and easily from one length to the other by simply
lifting the mobile stopper out of the way.
By adding and setting additional mobile stops it is possible to set other cutting lengths.
$!!
on the stop (3) and run it along the guide until it comes up against
the workpiece and then retighten the handle.
Repeat this procedure for the other measurements and stops you
wish to position.
NOTE – Being as it is not possible to determine the exact
measurement between the middle line on the graduated
measurement and correct if necessary.
2
1
45°
45°
3
A
B
