Flashforge Creator 3, Руководство пользователя

Страница: 49 / 100

1. Tap[Preheat],set heating temperature,then go back.
2. Tap[Tools]-[Filament]-target extruder[loading], wait for extruder to heat up. As filament starts to purge, insert the
unclog tool into the extruder intake (top).
3. Clogged debris will be pushed down and will extrude from the extruder tip. You should push the unclog too all the
way down to ensure all filament is purged. You do not need to push with excessive force, as this may damage the
extruder.
1. Please cover the top and close the front door to prevent the device from falling into dust when not using the device.If
the device has not been used for a long time, it is recommended to use the original packaging.
2. Grease moving parts regularly.For frequent users, add grease at least once every three months;For long-term
nonusers, add grease at least every six months.
3. Please clean residue and other sundries in time after printing completed, avoid sundries falling affecting device use.
4. As consumable, build tape may be damaged when adhesive force declined;Please change build tape in time to
avoid affecting print effect.
5. Whenever possible, it is best to locate your object in the center of the build platform. Using the best orientation for
your object is critical. Ensure that your object is located on the build platform and that you are using the best orienta
-
tion for building.
6. For steep overhangs (Less than 45 degree angle) it is recommended to build with support.
6.3 Extruder Unclogging
6.4 Daily Maintenance and Use Suggestion
48