37
Tap more buttons during printing
Real-time check or change: filament setting, light-off setting,print details(print speed,filament use,print time,Z-axis
coordinate)
1.
Filament changing:
Tap[Filament] to change filament during printing.(This function works after pausing printing).
2.
Turn off the light:
Tap[Light off]to turn off the lights during printing.
3.
Details:
a）
Print speed:
To set print speed value during printing.
b）
Filament use:
Check filament usage amount.(m)
c）
Print time:
Check print time
d）
Z-axis:
Check Z-axis coordinate
e）
Back:
Cancel tool instructions,go back to print interface.
To set extruder printing speed during printing
To set the printing speed during printing: Tap [Yes] to save the setting while tap [No] to cancel the setting.
To modify left/right Extruder and baseboard
temperature:
After temperature has reached target temperature,
temperature figure will be underlined in print interface,
choose number box,modify extruder temperature by
tapping ‘-’ ‘+’.Tap [Yes] to save the setting while tap [No] to
cancel the setting.
Print interface
1.
Abort:
To abort the print job.
2.
Pause/Resume:
To suspend or resume the print job.
3.
More:
Real-time check or change: filament setting,
lights-off setting,print speed,print schedule,filament
usage,print time and Z-axis coordinate
4.
Left/Right Extruder temperature,build plate
temperature:
Can be modified during printing.
Содержание Creator 3
