8 |
P a g e
MANUAL MODEL LIST & INFORMATION
The Following manual should be used for the following Flare Fireplaces Models:
•
Flare Front 120,140,160,180-400
“
–
16” (R), 24” (H), 30”
(EH)
•
Flare See-Through 120,140,160,180-
400”–
16” (R), 24” (H), 30”
(EH)
•
Flare Corner Right & Left 120,140,160,180-400
”
–
16” (R), 24” (H)
•
Flare Double Corner 120,140,160,180-400
”
–
16” (R), 24” (H)
•
Flare Room Definer 120,140,160,180-400
”
–
16” (R), 24” (H), 30”
(EH)
All Flare Fireplaces large models share the same gas valve system, gas connection, and glass type, simplifying
installation and operation.
Flare Fireplaces vent run calculation should be checked and planned based on the relevant fireplace size.
All warnings and instructions apply to all models.
Refer to the model name for specific model, clearance and installation information.
Flare Fireplaces should only be connected to M&G DuraVent 5x8 venting system or 3x5 ( in case of a PV system ).
Refer to the specific appliance model and size to determine vent size (Gas specification table) and chimney pathway
requirements (
Chimney path installation & planning table
). For detailed chimney installation information please use
the M&G DuraVent direct vent installation manual:
For details on ICC direct vent installation, please use the ICC installation guide.
http://icc-chimney.com/en/exceldirect-support
This product is listed to ANSI standards for “Vented Gas Fireplace Heaters” and applicable sections of “Gas Burning
Heating Appliances for Manufactured Homes and Recreational Vehicles”, and “Gas Fired Appliances for Use at High
Altitudes”.
Installation MUST comply with local, regional, state and national codes and regulations. Consult insurance carrier,
local building inspector, fire officials or authorities having jurisdiction over restrictions, installation inspection and
permits.
This installation must conform to local codes. In the absence of local codes, you must comply with the
National Fuel Gas Code, ANSI Z223.1-latest edition in the U.S.A. and the CAN/CGA B149 Installation Codes in Canada.
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified service technician, service agency or your dealer.
FLARE REQUIRES INSTALLATION BE
PERFORMED BY AN NFI CERTIFIED INSTALLER,
OR A CERTIFIED FLARE DEALER.
INSTALLATIONS THAT DO NOT FOLLOW THIS
INSTRUCTION WILL NOT BE COVERED BY
WARRANTY OR SERVICED.
Содержание Corner Right & Left 120
