Manual
Compressor
Assembly and first use:
The compressor is delivered in a packaging containing:
• manometer
• wo anchor safety chains
• hose 4m length
•
tyre inflator valve connector
•
pipe fittings
The compressor is factory tested. During the first use, operate as follows:
1.
install the device as per chapter „Installation“
2.
proceed with the use as per chapter „Operating instructions“ by carrying out a running-in phase
of aprox 30 min.
3.
while running-in, carry out the checks as per chapter „Operating instructions“
Make sure the compressor shaft rotates freely, during the first use, the compressor could not freely
rotate as it needs a short running-in period.
Installation:
Make sure the compressor shaft rotates freely.
The compressor dragging shaft is hollow, allowing it to receive the power take-off shaft on which
the compressor must be placed. There is only one possible mounting direction.
WARNING!
Insert the compressor with the engine off (picture no. 2)
picture no. 2
picture no. 3
picture no. 4
picture no. 5
If the compressor is blocked, DO NOT USE THE PTO POWER TO UNLOCK IT. Carry out mainte
-
nance operations, since the compressor might be reusable and you avoid the risk of breaking the
hooking chain.
See pictures no. 2 and 3 for compressor installing operations. It is important to carry them out fol-
lowing what is explained hereafter until the safety chains oppose effectively and safely the drag
-
ging coupler:
•
Connect the compressor shaft with the tractor power take-off (PTO)
•
Drive the compressor until its inside threaded sleeve touches the tractor PTO.
•
Screw the grub screw on the dragging shaft to block it on the tractor PTO. Operate with a
ca.2.5/3daNm torque.
