INSTRUCTION MANUAL
Electrical winches LM500+/300S+
Réf : 1813000208
Page :
5/20
Version : 39/21
-
every day the correct operation of the
mechanisms, brakes, and emergency stop
-
periodically the electrical cables, limit
switches, structural elements and wire ropes
-
regularly the presence of travel end stopper,
the presence of plates and safety instructions
(and their readability),
-
safety of the suspension structure
-
there is no accumulation of snow, ice, debris
or materials on the winch,
-
that there are no obstructions on the façade or
in the shaft
-
at the end of work, that the deactivation is
complete.
-
If a charge is to be raised by multiple devices,
the installation of these must be preceded by a
technical review by a competent technician
and then conducted according to this study,
including to ensure the constant distribution
of the load in suitable conditions.
During the operations of lifting, up and down,
the user must constantly observe the load and the
free end of the cable to prevent any risk of collision.
The load must be constantly guided (EN14492-2);
otherwise the use of rotation-resistant wire rope is
necessary.
Check and apply local regulations concerning
the installation, use, maintenance and control of
lifting devices.
See also contraindications §2.6
1.7
Anchoring
Verify that the anchoring point is strong enough for
the effort to apply.
If the anchoring is not provided by FIXATOR each
anchor must withstand, without any deformation, up
to 2.5 times the WLL of the winch, that is 1250 kg
(respectively 750kg for a WLL of 300kg), and
remain stable when subjected to this load.
(special case of reeving 2:1, the resistance must be
of 5 times the WLL, that is 2500kg (respectively
1500kg); see §2.1.4)
Minimal withstanding of the hoist and/or pulley
anchorage :
If the fixing of the unit must be in a dangerous place
for the operator, the safety precautions provided for
by the
work’s
regulation must be taken to exclude
any risk uncontrolled in this operation. It is perhaps
better in this case to implement the hoisting cable
into the device before the anchoring operation.
Document téléchargé par [email protected] - 2022-03-11 15:38:39
