9
Humminbird:
Humminbird users need to modify the lower
transom mount plate by drilling out the little tab
shown in the photo to the right
This tab allows for the proper span to the
mounting hole
If the tab is not on the Humminbird backing
plate, you will need to create your own
mounting holes to secure the plate to the disk.
To secure the transducer it will be necessary to follow the steps shown on the next page.
Similar assembly for all transducers using this Humminbird transom mounting kit.
1.
Secure ½ in long screw
lightly so plate swivels.
2.
Swivel and secure the
hinged piece. Adjust
cable length and
position into cable slot.
3.
Turn into position,
tighten screw and
snap closed.
4.
Insert second screw ¾
in long
5.
Tighten the screw
6.
Secure transducer to
its assembly.
Humminbird XHS & XTM 9 HDSI series
1.
Lock washers are included to be inserted between the tabs of the transducer and the
tab on the mounting puck (only need to use if transducer remains loose after tightening
the bolt).
2.
Transducer should be mounted so its body is under the mounting puck and downrod.
3.
Mount the assembly to the downrod.