7
General Instructions:
1.
Place all items (cones, strain relief, handles, etc.) onto the downrod
–
do not
secure them. This includes the transducer mounting end, the cone, handles,
and spare cone if ordered and the heat shrink strain relief
2.
Remove the retaining screw for the downrod cone so it will not interfere with
the cable connector.
3.
Feed the cable through the transducer mounting end.
Lowrance users, see special note below:
4.
Secure the transducer to the downrod end using the general instructions on
the following pages.
Lowrance
: If you have a Lowrance
transducer with the blue or black connector,
it is possible to use it with a 1 inch OD
downrod with a bit of modification. You will
need to sand the nubs of the connectors in
order to get it through the downrod as
shown.