Fisher PRO-CASTER 0806, Руководство по установке

Страница: 9 / 16

Lit. No. 96210/96211, Rev. 00 7 June 15, 2008
4. Install the belt between the spinner shaft pulley
and the gear case pulley. Raise chute up to
bottom of engine base and tighten four mounting
bolts.
5. Verify the pulleys are in line, the set screws are
tight and there is adequate clearance between the
pulley and the engine mount.
6. To adjust belt tension, loosen the spinner shaft
bearing bolts and move the spinner shaft away
from the gear case. Correct belt tension allows
1/4" to 5/16" de
fl ection midway between the
pulleys when belt is pushed with your fi nger. Make
sure the spinner shaft is vertical and the pulleys
are lined up before retightening the fasteners.
7. 26" Chute Only – Secure the access panel onto
the chute housing.
8. Tighten all fasteners according to the torque chart.
Chute Assembly – Center Belt Drive
NOTE: Chute assembly is a two person activity.
NOTE: For an alternate chute mounting
procedure, see instructions for mounting to a
hydraulic hopper.
1. 26" Chute Only – Remove the access panel on
the back of the chute housing.
2. Loosely attach the chute assembly using four
3/8" x 1" carriage bolts, fl at washers, lock washers
and nuts with the heads of the fasteners on the
inside of the chute.
3. Push the chute assembly toward the front of the
vehicle. DO NOT tighten the bolts at this time.
1/4" – 5/16"
Deflection
Chute
Mounting
Holes
CHUTE ATTACHMENT INSTRUCTIONS
CAUTION
Overtightening the belts may damage the
bearings on the gear case, the engine and/
or the spinner shaft. Overtightening will also
shorten the life of the belt.