Fisher PRO-CASTER 0806, Руководство по установке

Страница: 15 / 16

Lit. No. 96210/96211, Rev. 00 13 June 15, 2008
Conveyor
Chain
Rear Edge
of Sill
1" – 3"
20" – 24"
FINAL ADJUSTMENTS
Final Checklist Drive Chain and Conveyor Chain
Check engine to electric clutch chain tension and
clutch to spinner pulley belt tension. Correct tension
allows 1/4" – 5/16" de
fl ection midway between the
pulleys.
To increase spinner belt tension: Loosen spinner
bearing bolts, and pull shaft assembly away from the
clutch. After correct tension is achieved, retighten the
bearing bolts.
Check the conveyor chain tension. To check the
tension, measure in 20"–24" from the end of the sills.
Push up on the chain with your hand. The conveyor
chain should lift 1"–3" off the conveyor chain guide or
cross angles.
To increase chain tension: Use the two
5/8" x 6" take-up bolts at the front of the spreader to
adjust conveyor chain tension. Loosen the locknuts
before attempting to adjust the take-up bolts. Turn
both bolts equal amounts to ensure the tension is
equally distributed across both sides of the conveyor
chain.
Verify correct engine oil level. (See engine
manufacturers Owner's Manual.)
Verify the gear case oil level is level with the fi ll
hole.
Verify correct engine-to-clutch sprocket alignment
and chain tension.
Verify correct gear case output shaft to spinner
shaft alignment.
Verify correct conveyor chain tension.
Verify dielectric grease is applied to all electrical
connections.
Verify wire harnesses are properly secured away
from hot or moving parts.
Verify vehicle harness has suf fi cient ground
clearance when the spreader is removed from the
truck.
Verify proper choke setting and choke light
operation. See Choke Adjustment Procedure.