Fisher PRO-CASTER 0806, Руководство по установке

Страница: 10 / 16

Lit. No. 96210/96211, Rev. 00 8 June 15, 2008
4. Push the chute assembly toward the front of the
vehicle. DO NOT tighten the bolts at this time.
5. Install the belt between the spinner shaft pulley
and the gear case pulley. Raise chute up to
bottom of engine base and tighten four mounting
bolts.
6. Verify the pulleys are in line and the set screws
are tight. (You may have to lower the pulley on the
chute about 2 inches).
7. To adjust belt tension, loosen the spinner shaft
bearing bolts and move the spinner shaft away
from the gear case. Correct belt tension allows
1/4" to 5/16" de
fl ection midway between the
pulleys when belt is pushed with your fi nger. Make
sure the spinner shaft is vertical and the pulleys
are lined up before retightening the fasteners.
8. Additional belt tension may be applied by pulling
the chute assembly toward the rear.
9. Install belt guard.
10. 26" Chute Only – Secure the access panel onto
the chute housing.
11. Tighten all fasteners according to the torque chart.
1/4" – 5/16"
Deflection
Chute
Mounting
Holes
CHUTE ATTACHMENT INSTRUCTIONS
Chute Assembly – Center Belt Drive
Hydraulic Hopper
NOTE: Chute assembly is a two person activity.
1. 26" Chute Only – Remove the access panel on
the back of the chute housing.
2. Remove belt guard from hopper.
3. Loosely attach the chute assembly using four
3/8" x 1" carriage bolts, fl at washers, lock
washers, and nuts with the heads of the bolts on
the inside of the chute.
CAUTION
Overtightening the belts may damage the
bearings on the gear case, the engine and/
or the spinner shaft. Overtightening will also
shorten the life of the belt.
Belt Guard