If you have difficulty ground balancing, try reducing your
sensitivity level or moving to another spot just in case you are
over a buried piece of metal. In some areas of high ground
mineralization you may not be able to use the pushbutton
method.
IMPORTANT NOTE:
If you body mount your CZ-70 Pro,
you'll find that the "Bobbing" method is the easier of
the following two ground balancing methods.
"Pushbutton" Ground Balance Method
This will probably be your method of choice unless you have
body mounted your CZ-70 Pro or you are in highly mineralized
ground. It's fast, easy and accurate. You can use this method
in either the Autotune or Target LD. mode.
1.
With your controls set as in the "Turn-On"
procedure (See page 9/GROUND BALANCE
control at 10), hold your search coil parallel to
the ground and 6 to 12 inches off the ground.
2.
Make sure you're at least 3 feet away from
any metal objects.lower the coil to the ground.
Keep your thumb on the SEARCH/PINPOINT
button, and with your other hand, rotate the
GROUND control counterclockwise (starting at
10) until you hear an audio tone. Then back off to
the exact point where the tone disappears.
Release the SEARCH/PINPOINT touch pad and
you're ground balanced and ready to search.
3.
Always ground balance your CZ-70 Pro in the
areas you intend to search.
NOTES:
1.
If you get an audio response as you first lower
the coil with the GROUND BALANCE knob at 10,
GROUND BALANCING
18
