Fischer Panda 15000i PMS, Руководство пользователя

Страница: 149 / 176

General operation
4.5.16 Kapitel/Chapter 12: General operation - Seite/Page 149
12.3.3.6 Stop mode
By activating the Start/Stop button in operation mode, i.e., while the generator is running, you will stop the generator.
After stopping the generator, the system will return to stand-by mode. The display status field reads "STOPPING".
If the icontrol system detect a high cylinder head temperature (for example after a long time running with high load)
the icontrol start a stopping delay timer. The Display shows „Cooldown“ and a countdown.
During this timer the icontrol system will shut of the PMGi and run the engine at idle speed. During the delay time an
automatic start request will be ignored.
After the delay time, the generator will be stopped automatically.
You can interrupt the delay time by pressing the start/stop button. (Not recommend by Fischer Panda. The Engine
may overheat)
Fig. 12.3.3.6-1: Delay time
Attention: Never use an emergency stop switch for a regular stop
of the generator.
The engine may overheat and can be damaged/destroyed
Note: Manual start in autostart mode If the generator is manually started up and stopped while in
automatic start-up mode, it will switch to stand-by mode for
safety reasons.
If necessary, the autostart mode must be reactivated.
12.3.3.7 Autostart mode
The Panda iControl2 panel is equipped with an autostart function. A jumper between pin 6 (UBAT) and pin 7
(USTARTI of the Phoenix jack of the control panel starts up the generator with a delay of 5 seconds when the
autostart function is active. Removing the jumper will stop the generator - also with a delay of 5 seconds.
To activate the autostart function, you must first check the "Autostart" flag in the set-up menu. To activate the
autostart function, read Siehe “Activating/deactivating the autostart function ("Autostart")” auf Seite 153.
Fig. 12.3.3.7-1: Default display screen in autostart mode
The display status field reading "AUTOSTART" indicates
that the autostart function is active, or, if it reads
"STANDBY", this means that the autostart function was
deactivated.