Fischer Connectors FO2-4, Инструкция по сборке

Страница: 7 / 27

Assembly instructions Rev6.0
7
This document is the property of Fischer Connectors.
This document must not be reproduced or distributed, in whole or in part, without prior written permission of Fischer Connectors.
Screw the Clamp Nut ”I”.
Recommended torque : 5.0 Nm
Note : hold the Clamp Set Body
with a wrench while screwing the
Clamp Nut “I”. Torque wrench [3Nm]
Size 9
Wrench size 10!
Slide the Shrink Tube "K" until the
end of the shrink tube bottoms
against the Back Nut “J” and heat
it.
Heat gun
Shrink tube operating
temperature Range : -
55°C to 110°C.
Apply epoxy on the Shrink Tube
"K" and slide the Bend Relief ”L”
until the end of the bend relief
bottoms against the Back Nut “J”. Epoxy: RT-355
Resintech
Insert Sleeve Holder "A" in the
Connector Body "B".
Note : there is no sleeve holder
for R01, R03,R13 and R50
receptacles. Thus, this final
assembly step is valid only for
P01 plug.
5
6