Assembly instructions Rev6.0
6
This document is the property of Fischer Connectors.
This document must not be reproduced or distributed, in whole or in part, without prior written permission of Fischer Connectors.
Screw by hand the Rear Nut “J”
on the Connector Body “B”, then
uniformly distribute the cable
strength members around the
back of the Clamp Set Body “G”.
Position the Conical Ring “H”
against the strength members.
Screw by hand the clamp nut “I”
on the back body clamp “G”.
Screw the Rear Nut "J”
Recommended torque : 5.0 Nm
Torque wrench [5Nm]
Size 13
Counter piece:
receptacle FO2/4
