Assembly instructions Rev6.0
4
This document is the property of Fischer Connectors.
This document must not be reproduced or distributed, in whole or in part, without prior written permission of Fischer Connectors.
4
FO2-4 Plugs & Receptacles with Cable Clamp Set
Assembly steps
Components list :
A – Sleeve Holder
B – Connector Body
C – Insulator
D – Termini
E – Support Washer
F – O-ring Seal
G – Clamp Set Body
H – Conical Ring
I – Clamp Nut
J – Rear Nut
K – Shrink Tube
L – Bend Relief
Note : the pictures shown in this section represent a P01 Plug.
The following assembly steps are valid for P01 plug, as well as R01, R03, R13 and R50 receptacles, except the final
step (sleeve holder assembly).
Picture
Process
Tools
Slide over the cable :
-
the Bend Relief “L”
-
the Shrink Tube “K”
-
the Rear Nut “J”
-
the Clamp Nut “I”
-
the Conical Ring “H”
-
the Clamp Set Body “G”
-
the O-Ring Seal “F”
Strip the cable to the dimensions
as given on the picture.
Ruler, aramid shears,
jacket stripper,
and strip tool
Terminus assembly : See section 7
Polishing: See section 8
Insert all the termini “D” into the
insulator “C”.
When you insert the terminus
”D”, be careful to turn it during
the insertion to not “bend” the
contact O-ring.
A
B
C
D
E
F
G
H
I
J
K
L
