First Degree Fitness Vortex VX3 FA, Руководство пользователя

Страница: 26 / 29

26
Troubleshooting
Problem Solution
Rowing Belt cannot extend to the
end of rowing stroke or there is no
resistance.
Rowing Belt needs to be unwrapped 1 turn or, requires an
extra wrap on the Rower Belt Pulley.
The computer display is erratic
while displaying SPM and 500m times.
This problem may occur if the gap between sensor and
magnetic ring is too wide. To fix, remove large service cover
and check gap between sensor and magnetic ring (should be
no more than 2.5mm).
Further instructions can be found at www.firstdegreefitness.zendesk.com. To ensure maximum lifespan and
optimal performance follow these steps:
1. Keep your VX-3 FA in a dry, clean climate controlled environment at room temperature.
2. Check your bungee cord and rowing belt every 100 hours for correct tension and signs of wear. Adjust
tighten as required. If a Bungee Cord change is required, please contact a local service representative
or visit www.firstdegreefitness.com/support
3. Only treat tank water with FDF genuine water tablets. Refer to ‘water treatment’ section on page 16.
4. Periodically clean your Rower with disinfectant, applied using a lint free cloth.
5. Keep dust off the Rower, especially the seat wheels and runners.
6. For information on how to service your machine visit www.firstdegreefitness.com/support