First Degree Fitness TRIDENT Challenge AR, Руководство пользователя

Страница: 18 / 21

18
Hint
If Bungee Shock Cords previous tension seemed
correct (a good way to judge is if the Rower Han-
dle can make it to the furthest point forward on
the top of the Mainframe under bungee tension
alone) then simply tie off at previous position. If
the return is too slack, experiment by tightening
the tension in
Bungee Shock Cord
Bungee Pulley
Removing the Bungee Shock Cord
Bungee
Shock Cord
Bungee Attachment Point
Upper Frame Plug
Upper Frame Hole
Belt/ Bungee Pulley
4.Rethread the Bungee Shock Cord (on
opposite side of the Idle Wheel) back
through the Bungee Pulleys and tie off
at the Attachment Point.
First, move the Rowing Handle to it’s far-
thest forward point on the Mainframe,
then cut the plastic end tie and follow the
drawing above for bungee removal.
Next, remove the Upper Frame Plug to
allow the Bungee Shock Cord to be
threaded through the top of the frame.
Note: You will need to rotate the Belt/
Bungee Pulley to align the holes proper-
ly. Should the belt drop off of during the
bungee change, please refer to the previ-
ous pages for “Attaching/Reattaching
the Rower Belt”.
Once Bungee Cord and Upper Frame
Hole are aligned, push the Bungee Cord
up and through the frame as shown
small increments and testing until the correct tension is achieved. If the Rower
Handle cannot reach the end of the seat rail during a rowing stroke, then the
Bungee Shock Cord is over-tensioned.