Page 12
Installing cameras
connecting devices
Splitter -
8 camera/
1 Power
Video to DVR
Channels 1-8
Video to Camera
Power to Camera
Power to DVR
Power to Cameras
Power
from 120V
DC Converter - 12V
AV Cable: BNC/
DC Power
(1 per Camera)
VGA to PC Monitor or TV
BNC to Security Camera Monitor
(Not included)
RJ45 Ethernet
to Router and
Internet
PTZ & Alarm
Connections
(Cameras not
included)
Follow this diagram to make device connections. Note, some devices are
not included with this kit. See “What’s in the Box” for included devices.
DVR Front Face
Connect Mouse &
USB Drive
product overview
cAMERA AND pOWER cONNECTIONS
RCA Audio In from Audio
Cameras or Powered
Microphone
(Not included)
RCA Audio Out to
Powered Speakers
(Not included)
Smartphone
through Mobile
Internet Setup
(Smartphone Not
included)
Installing Cable-Safe Mounting Bracket
Decide if the camera is to be wall or ceiling mounted and if cable will be fed
through mounting surface hidden directly behind the bracket or fed through
the side of the bracket so cable is exposed. Mark area where you will drill your
hole. The Cable-Safe Mounting Bracket has three Adjusting Points. 1) Rotates
Bracket 360° relative to mounting surface, 2) Adjusts bracket hinge 180° and
3) Rotates camera body 360° to level image.
Step 1:
Select the position for the camera and drill your hole for the cable.
Feed cable through mounting surface. Mount bracket to surface.
Step 2:
Aim camera at target and using Adjusting Points 1 and 2 in tandem
position camera. Tighten Ring and Thumb Screw.
Step 3:
Rotate camera body using Adjusting Point 3 to the proper view angle
making sure the Camera Shield is always on top and parallel to the ground so
the image is level in the Live View Screen. See “Camera Orientation” Info box.
Tighten screw.
Step 4:
Attach proper length of cable and run from camera to DVR location.
Note: Power cable ends are different. Be sure the correct power connector
end matches “To Camera” or “To DVR”. Tip - Connect cable at camera end
before running cable to verify orientation is correct. Also, see Information box
on “Longer Cable Runs”.
Step 5:
Check camera orientation via the Live View screen. Adjust as required.
Adjusting Points
1
3
2
Screw
Thumb Screw
Ring
Slot for exposed
cable installation
To DVR
To Camera
Verify Cable Orientation
