2
ORDERING INFORMATION
REMOTE MOUNT THE ED510 DISPLAY USING 129-145 MOUNTING KIT
See Figure 1. The 129-145-1, -2, or -3 is used to panel mount the ED510 display.
To install the ED510 display module using the remote mounting kit (129-145-1, -2 and -3):
1.
Cut an opening in the front panel face 3.62 inches square (92.0 mm). The width of the panel face
cannot exceed 5/64."
2.
Slide the gasket over the rear side of the display.
3.
Insert the ED510 display and gasket through the panel opening.
4.
Insert the mounting plate over the rear side of the display. Slide the two (2) mounting tabs on the
mounting plate over the slots on the ED510 display. Then move the mounting plate until the tab
on top of the ED510 display snaps into position under the opening on the mounting plate.
NOTE: Align the mounting plate so when the mounting screws are installed and tightened, the
threaded inserts are not pushed out of the mounting plate.
The mounting plate has a 1/2" circular opening to allow access to the contrast adjustment potentiom-
eter on the rear of the ED510 display.
5.
Insert the mounting screws into the threaded inserts and tighten.
6.
Insert the 2 foot cable (129-145-3), 4 foot cable (129-145-1) or 8 foot cable (129-145-2) into the
RJ45 style connectors on both the ED510 display and the EP Programmer Module (Engineering
code 28 or later). A ferrite core is provided on the ED580 cable to improve the electrical noise
immunity of the FLAME-MONITOR system.
The connector nearest to the ferrite core must
be plugged into the EP Programmer.
TO ENSURE THE SYSTEM IS PROPERLY GROUNDED:
1.
Connect the back plane of the mounting cabinet to a proper earth ground.
2.
Ground the FLAME-MONITOR wiring base to the mounting cabinet by using mounting
screws with star washers to ensure proper electrical contact.
3.
Connect the green grounding screw on the wiring base to a proper earth ground.
NOTE: A PROPER EARTH GROUND CONSISTS OF A METAL ROD DRIVEN INTO THE GROUND AT A
LOCATION NEAR THE ELECTRICAL DISTRIBUTION PANEL PROVIDING POWER TO THE FLAME-
MONITOR CONTROL SYSTEM. REFER TO SN-100.
Refer to the ED610 to remote mount the display greater than 8 feet away from the control.
PART NUMBER
DESCRIPTION
129-145-1
Remote mounting kit (includes ED580-4)
129-145-2
Remote mounting kit (includes ED580-8)
129-145-3
Remote mounting kit (includes ED580-2)
ED610
Multi-port connector with terminal strip and phone jacks.
ED512-2
2 foot cable with RJ12 (4P4C)
connectors for connection to E500.
ED512-4
4 foot cable with RJ12 (4P4C) connectors for connection to E500.
ED512-8
8 foot cable with RJ12 (4P4C) connectors for connection to E500.
ED580-2
2 foot cable with RJ45 connectors for remote display.
ED580-4
4 foot cable with RJ45 connectors for remote display.
ED580-8
8 foot cable with RJ45 connectors for remote display.
ED150-3
3 foot remote reset cable
ED150-6
6 foot remote reset cable
ED150-15
15 foot remote reset cable
ED150-25
25 foot remote reset cable
EC485
RS485 to RS232 Converter with optional RJ12 (4P4C) connector and power
supply
