Kalea Bay Outdoor Fireplace
REV. 4-17-19 Page 25
FINAL PREPARATION
BURNER P
AN ASSEMBL
Y
Pilot
(Hidden Underneath)
Burner
Tube
Ignition
Hole
FLAME HEIGHT
Fig. 31
Proper flame height.
Proper flame height (Fig. 31) should be at the top edge of glass windshield (peaking above at times) while on HI setting.
Note:
Glass windshield is 7-inches tall. The LO setting will be at least half of the height of HI or maybe lower. There can
be a variance in flame height between Natural Gas and Liquid Propane (LP) Gas models.
1. T
o
LEARN
(pair) the remote transmitter to the control module, press and release the LEARN button (switch) in the
control box. See Fig. 32. You will hear single audible beep indicating the module is ready to learn the transmitter
security code. Press any button on the transmitter within 60 seconds. The code is accepted when you hear 4 short
beeps in rapid succession. Security codes will be retained in memory indefinitely if power is removed.
Note
: Control
module accepts a total of three (3) wireless transmitters.
2. To
Clear Codes
: Press and hold learn switch on for 6-seconds to clear all transmitter security codes retained in
memory. Codes are clear when you hear three long beeps in succession.
Note
: After “Learning” the remote control to the control module you will be able to operate the fireplace with the
remote, without pushing any of the switches inside the control box. You still have the option to operate the fireplace
manually if needed by accessing the control box and pushing the ON/OFF switch. Refer to the lighting instructions above.
LEARNING TRANSMITTER TO MODULE
PROGRAMMING OPTIONAL REMOTE CONTROLS
1
2
GLASS
WINDSHIELD
GLASS WINDSHIELD
Side View
Installing Glass
Side View of
Installed Glass
Bottom Tab
Bottom Tab
WINDSHIELD INSTALLATION
The glass windshield(s) slide into the glass holders on each
end of the fireplace and rest in position if installing for the
fireplace (See Fig.30) for the location. Use two screws
(#77129) for each glass holder. Insert screws into the
installed in the fireplace side wall to secure the glass
holders. There is one glass windshield provided with this
fireplace. The glass will rest on the bottom tab of each
windshield glass holder.
CAUTION:
THIS IS TEMPERED GLASS. DO NOT CHIP
GLASS. CHIPPED TEMPERED GLASS CAN BREAK
WITHOUT WARNING.
Fig. 30
Proper flame height.
Fig. 32
Control panel
ON/OFF
LOW
HIGH
LEARN
CONT.
PILOT
