Firecraft P30G FXL01, Инструкция по установке и эксплуатации

Страница: 7 / 20

UNPACKING THE APPLIANCE
Stand the carton the right way up, cut the strapping bands and remove the top endcap. Read
ALL these instructions before continuing to unpack or install this appliance.
Remove the box containing the cast front fret, and the box containing the ceramic coals and
other ceramic firebed components. Remove the cardboard packing pieces and any other bags
or boxes containing fittings or other parts. When all loose parts have been removed, the outer
sleeve may be lifted off to reveal the appliance. Check that the components supplied against the
component checklist. Please dispose of all the packaging materials at your local recycling cen-
tre.
COMPONENT CHECKLIST
QUANTITY DESCRIPTION
1 Cavity box, firebox and burner assembly fitted with glass panel
1 Decorative frame
1 Hood
1 Cast front fret with separate ashpan door
1 Moulded ceramic fibre combustion fuel bed
1 Ceramic pad set
1 Sealing grommet
1 Cable fixing kit
1 Screw and rawl plug pack
1 Set of manufacturers instructions
APPLIANCE INSTALLATION
Note: Ensure that the gas supply is isolated before commencing installation of the appli-
ance.
The fireplace opening and environment must be in compliance with specifications laid down in
the appropriate sections of these instructions.
PREPARING THE APPLIANCE
Remove the appliance from its carton as described previously and stand on a dustsheet. Remove
the glass panel and place it and the coals, ceramics and fixings safely to one side.
Lay the fire on its back. Remove the firebox assembly from the cavity box by removing the fix-
ings provided on the front of the firebox frame. Place the firebox to one side for the time being.
Knock out holes are provided in the rear and sides of the cavity box for use where concealed
pipework is required. Note: Knock out holes are also provided in the sides of the inner firebox if
a side-entry pipe routing is required, but it is not necessary to seal these holes with grommets.
Knock out the appropriate hole in the cavity box with a sharp tap from a hammer and fit the rub-
ber grommet supplied. A small incision can now be made in the rubber to slip snugly around
the outside of the supply pipe and sleeving.
Note: Do not install or use the appliance without this seal in place.
4
5.0
5.1
6.0
6.1