FUEL BED (continued)
Fit the glass door assembly with the 4 screws provide in
the positions indicated. Ensure that the screws are tight-
ened so as to achieve a good seal between the glass
frame gasket and the firebox.
The fire is designed to operate correctly with the sup-
plied components according to the instructions. Never
add coals. Never put combustible or non-combustible
materials, rubbish or other matter into the fire. Please
note that it takes approximately 15 minutes for the full
flame effect to be achieved.
FITTING THE DECORATIVE FRAME AND HOOD
The appliance is supplied with a decorative frame and hood.
The frame attaches to the firebox using either four magnetic pieces, or as a three piece clip-on
assembly. The side pieces of the clip on assembly should be pushed into position first, followed
by the top bar, which should overlap the sides. For the single piece assembly, magnets should
be fitted to the steel backing plates. A plastic pro-
tective coating may be applied to the face of the
frame assembly, which should be removed at this
stage.
IMPORTANT : Due to the possibility of sharp
edges, care should be taken when handling the
three piece frame components. The use of pro-
tective gloves is recommended.
Place the firefront into position in front of the fire
and slide the ashpan door into place. Do not use
any other firefront other than the one supplied
with this appliance. The firefront shown in these
instructions may differ form the one supplied with
the appliance.
Fit the convector hood to the firebox by engaging
the two mounting hooks into the relevant slots in
the firebox. The hood should be pressed inwards and downwards to secure into position.
TESTING AND COMMISSIONING
As previously mentioned, firstly turn on and test the gas supply up to the fire for any leaks, in
accordance with current Approved Codes of Practice (ACOPs).
OPERATING THE APPLIANCE
The pilot is visible through the left hand side of the matrix.
Push in and turn the control knob to the SPARK position, and hold there for
a few seconds.
Continue turning anti-clockwise through the spark click to the PILOT light
position, ensuring the pilot has lit. If not, return the knob clockwise, and
repeat.
When the pilot lights after the spark, keep the knob depressed for approximately ten seconds.
Now release the knob and the pilot should stay alight. If the pilot extinguishes during use, wait
three minutes before repeating the ignition procedure. To achieve the HIGH setting, push the
control knob in slightly and continue turning anti-clockwise to the high position. The main burn-
er should light after a few seconds. To decrease the setting to LOW, turn the control knob clock-
wise to the low setting.To turn to the PILOT position from the HIGH or LOW positions, press the
control knob in, and return to the pilot position and release. To turn the fire OFF, keep the knob
pressed in, return to the off position and release.
10
9.0
10.0
11.1
11.0
Содержание P30G FXL01
Страница 2: ...FXL01...
