OPERATING INSTRUCTIONS - continued
To turn to the PILOT position from the HIGH or LOW positions, press the control knob in, and
return to the pilot position and release. To turn the fire OFF, keep the knob pressed in, return to
the off position and release.
COMBUSTION MONITORING SYSTEM
This fire is fitted with a combustion monitoring safety device (ODS). If the fire shuts down dur-
ing use for no apparent reason then several reasons may be suspected. If a door or window has
been opened creating a draught, then pilot disturbance could be the problem and removal of the
draught should resolve this. The fire can then be re-lit in accordance with the previous section.
A grommet seal may also be missing from the firebox causing abnormal draught to shut down
the pilot. Call your installer to check seals are properly fitted.
If pilot disturbance is not the cause, then the ODS safety system may be in operation. Switch the
appliance OFF, call in your installer to check the appliance and ventilation. Remedial work must
be carried out as required. DO NOT allow the appliance to be used until the appliance and instal-
lation is passed as safe. If the pilot continues to be extinguished you must call your installer to
check the operation of the complete appliance.
CLEANING
Before carrying out any of the following operations ensure that the fire is OFF and completely
cold.
Debris that may form on the fire bed should be periodically removed by a competent person.
Large deposits could indicate incorrect coal placement. This should be remedied by a competent
person and the fire serviced before further use. To gain access to the fire bed, remove the hood
and glass door assembly. The hood should be lifted and pulled outwards. Next remove the door
by removing the 2 screws and disengaging the 2 lugs at the bottom. The glass can be cleaned
using a proprietory hob cleaner. Test on a small area first.
FIREFRONT - Any dust accumulating in the fire front may be removed using a vacuum cleaner or
dry cloth. Heavy stains may be removed by using a damp cloth and mild household detergent.
Brass parts of the fire front may be cleaned using a suitable brass cleaner. Replace the front cen-
trally against the fire after cleaning.
PAINTED AREAS - These can be cleaned using a dry cloth.
CERAMICS
Refer to the relevant section of the Installation section of this booklet for instructions on clean-
ing and replacing the ceramics.
SERVICING
The fire should be checked on an annual basis to ensure it is working safely and that there is no
excessive build up of soot. The frequency of service will depend on usage but MUST be carried
out at least once annually. Servicing must be carried out by a competent person, such as a
CORGI registered installer.
Cleaning of the coals may be carried out by following the instructions given in the Installation
section. The Installation instructions carry full servicing details for the use by the installer.
LIST OF SPARE PARTS
PART NO.
ITEM
FT/F780054
Ceramic combustion matrix
FB/F550085
Ceramic brick panel set
FB004225/5
Glass door assembly
FT004135/5
Convector Hood
FT/F730023
Pilot assembly
FT003835/5
Burner tray
Please enquire
Gas valve
FB/F780052
Catalyst (seal kit must also be supplied)
FB/F940136
Seal kit for Catalyst
Please enquire
Decorative frame
Please enquire
Decorative fret
3
6.0
7.0
8.0
9.0
10.0
As our policy is one of continuous improvement and development , we hope therefore you will understand we must retain the right to amend
details and/or specifications without prior notice
.
DO005735/0
5.0
Содержание P30G FXL01
Страница 2: ...FXL01...
