Page
23
Notifier Inertia-888 User, Technical & Programming Manual
Copyright (c) 2005, Notifier Inertia
TO ENTER PROGRAM MODE
HOLD DOWN
ENABLE
SWITCH
& PRESS
PROGRAM
KEY ONCE
NOTE:
THE ENABLE SWITCH IS LOCATED ON THE BOTTOM LEFT HAND CORNER
OF THE MAIN PCB NEXT TO THE KEYBOARD RIBBON CABLE. IT IS MARKED SW1.
SYSTEM STATUS LED’s WILL FLASH TO INDICATE PROGRAMMING MODE ENTERED.
TO EXIT PROGRAM MODE
HOLD DOWN
ENABLE
SWITCH
& PRESS
PROGRAM
KEY ONCE
(THIS WILL AUTOMATICALLY SAVE CHANGES)
THE PANEL WILL BEEP, RESTART AND THEN RETURN TO NORMAL DISPLAY.
ZONE PROGRAMMING
Once you are in programming mode and have the panel status LED’s flashing.
Press the PROGRAM key once.
Press the Zone Number (1-8) you wish to program.
The Alarm led will indicate the zone to be programmed.
The Fault led will indicate the current zone type
The Isolate led will indicate the current zone output.
If you wish to change the settings of this particular zone
Press the Zone Type Number (1-7)
Press the Zone Output Number (1-4)
(an incorrect entry will give a long beep and be ignored)
Or simply press the program key and then the next zone number you wish to look at.
Example.
To set zone 4 as AVF and to Indicate only, do as follows.
Press
PROGRAM
4
2
1
