Version: July 2020
5
Burner Tray Installation Process
LPG
Natural Gas
GD6 RB 1200
Input 18-26 MJ/h
One gas injector at the
pilot side of the burner tray.
•
Install the burner tray by carefully lowering
the end opposite from the pilot meanwhile
holding up the pilot end, lower the burner tray
down and move towards the pilot in one
movement.
•
Ensure the burner tray is located correctly
into the burner bracket and the jets are
aiming into the burner tube inlet holes.
•
Install the burner tray by carefully lowering the end opposite
from the pilot meanwhile holding up the pilot end, lower the
burner tray down and move towards the pilot in one movement.
•
Ensure the burner tray is located correctly into the burner
bracket and the jets are aiming into the burner tube inlet holes.
•
On the pilot side gas injector, gently tighten (do not over tighten)
the 12mm brass nut
closest to the burner tray
.
GD6 RB 1400
Input 20-28 MJ/h
Two gas injectors one at the
right and one at left hand
sides of the burner tray.
GD6 RB 1600
Input 30-38 MJ/h
Two gas injectors one at the
right and one at left hand
sides of the burner tray.
•
Install the burner tray by carefully lowering
the end opposite from the pilot meanwhile
holding up the pilot end, lower the burner tray
down and move towards the pilot in one
movement.
•
Ensure the burner tray is located correctly
into the burner bracket and the jets are
aiming into the burner tube inlet holes.
•
Install the burner tray by carefully lowering the end opposite
from the pilot meanwhile holding up the pilot end, lower the
burner tray down and move towards the pilot in one movement.
•
Ensure the burner tray is located correctly into the burner
bracket and the jets are aiming into the burner tube inlet holes.
•
On the non pilot side injector, gently tighten both the 12mm
brass nuts. The injector will pull towards the burner tray.
•
On both the non-pilot and pilot side gas injectors, gently tighten
(do not over tighten) the 12mm brass nuts closest to the burner
tray.
Cover and end cap installation
GD6 RB Oxygen Depletion
Pilot
•
Under
NO circumstances
should the pilot
be replaced or removed,
GD6 RB Pilot cover
This model has one pilot
cover.
•
Replace the stainless steel pilot cover (2 x
screws) at the pilot end of the burner.
GD6 RB Burner end
caps
This model has two end cap
covers, One at each side of
the burner
•
Replace the stainless steel burner end caps
(3 x screws on each cap) at either end of the
burner.
Non-pilot side Gas Injector Pilot side Gas Injector
Non pilot burner
end cap
Pilot burner end
cap
Pilot cover
Oxygen depletion pilot
