START-UP AND OPERATION INSTRUCTIONS
Ecosmall
Rev. 000
29/11/2017
23/41
4.7.2 CHOOSING THE RIGHT DETERGENT
Choosing the right detergent is very important for efficient floor cleaning. Too strong a detergent could cause
damages. Low-foaming detergents or foam preventing additives should be used to prevent damages to the
suction motor; if these products cannot be procured, try adding 50cc of common wine vinegar to the recovery
tank before starting the cleaning cycle.
Make sure that the detergent used is suitable for the surface to clean. Fiorentini S.p.A. will
not accept any responsibility for damages caused by too aggressive detergents.
4.7.3 CONTROL LEVERS
Forward movement lever
(detail 1 fig. 4.8):
actuating it will control the machine forward
movement; the movement speed and direction can be adjusted from the control panel (figure 4.6).
Squeegee lifting lever (detail 2 fig. 4.8):
by moving down the lever the squeegee will be lowered,
by moving up the lever the squeegee will be lifted off the floor.
Solution tap adjustment lever (detail 3 fig. 4.8):
to adjust the water flow set the lever to your
required position: with the lever all the way forwards, the tap will be turned off; with the lever all the
way back, the tap will be turned fully on.
Brush plate lifting foot control (detail 4 fig. 4.8):
the pedal is in the rear lower part of the machine.
When moved out of its seat, the pedal will go all the way up to the end of its stroke and the brush
plate will be rested on the floor; conversely, to lift the plate off the floor, control the pedal back into its
original seat.
Parking brake (detail 5 fig. 4.8):
the machine is equipped with a parking brake in the right lower
side of he machine, next to the driving wheel. This brake will act on the wheel, preventing its rotation.
FIGURE N. 4.8
1
2
3
4
