START-UP AND OPERATION INSTRUCTIONS
Ecosmall
Rev. 000
29/11/2017
22/41
Below are the symbols on the control panel with a short description of the corresponding function:
Min speed
Max speed
Key switch
Suction on/off
Fwd/Reverse
movement
Scrubbing brushes on/off
4.7. OPERATION
Scrubbing operations are highly critical and specific experience will help you choose the right type of
scrubbing brush and detergent and determine whether or not a double cleaning cycle is necessary.
Carry out scrubbing in the following steps:
Power on the machine (figure 4.6 detail 2);
Start the scrubbing brushes (figure 4.6 detail 5) and lower the brush plate with the special lever;
Start liquid suction via the squeegee (figure 4.6 detail 4);
Lower the squeegee with the special lever (figure 4.8 detail 2);
Control the machine forward movement with the special lever (figure 4.8 detail 1); during work the
forward movement speed is lower with respect to the idle phase, however, it is possible to adjust the
machine forward movement speed via the special potentiometer (figure 4.6 detail 1).
After scrubbing completion, before drying completion, turn the water tap off with the special lever (figure 4.8
detail 3)
4.7.1 MACHINE PREPARATION AND START-UP
If the machine battery charger is plugged in, unplug the battery charger connected to the machine battery
and connect the battery plug to the machine power plug (fig 4.5).
Fill the machine with water through one of the two filler plugs in the rear part of the machine (figure 4.7); if
filling is done through a pipe, it is advisable to use the plug located on the right side (figure 4.7 detail 2), as
its inside cross-section is specially sized to enable efficient connection to the top-up pipes and to ensure
secure fastening during tank filling.
FIGURE N. 4.7
2
1
