MACHINE CHARACTERISTICS AND TECHNICAL DATA
ECOMINI
Rev. 000
18/09/2017
7/37
2. MACHINE CHARACTERISTICS AND TECHNICAL DATA
2.1. MACHINE IDENTIFICATION
An adhesive machine identification label containing indelible “CE” marking details is affixed on the rear side
of the machine next to the handle.
The label must never be removed and should always be kept legible. If the label is
damaged a duplicate should be ordered. The scrubber machine may not be sold without
this label.
2.2. DESCRIPTION AND COMPONENTS
The scrubber machine ECOMINI 430 has been designed to clean flat surfaces by means of washing
followed by washing water drying. The system is mains-powered via a 10 metres' long cable with a German
power plug or a 4 12V x 18Ah battery pack, powering all the machine parts and electrical controls.
The machine is equipped with a rotating brush designed to scrub the floor with water and detergent. When
the machine moves forwards, the squeegee or back brush, in contact with the floor, takes up any water by
suction for its subsequent delivery to the recovery tank.
Through the control panel, all the main machine functions can be activated. In particular, it is possible to:
Start the machine;
View the battery charge state (battery powered version);
Start vacuum suction;
Start brush rotation (via a special lever on the handle);
Adjust the handle angle (via a special lever provided on the handle);
Lift/lower the squeegee.
The main components of the machine are:
Washing fluid PPL plastic tank with draining hose;
Washing effluent plastic PPL recovery tank with one suction hose and one draining hose;
FIGURE N. 2.1
