START-UP AND OPERATION INSTRUCTIONS
ECOMINI
Rev. 000
18/09/2017
25/37
4.7.7 a BRUSH REPLACEMENT (STANDARD VERSION)
Proceed as follows to replace the brush:
Remove the key from the control panel to prevent unwanted starts (battery-operated version) or
unplug the machine from the mains power outlet (electrically operated version);
Empty both tanks to reduce the machine weight as much as possible;
Lift the machine and release the brush by rotating it clockwise (detail 1 fig. 4.14);
Position the new brush below the connector (checking that the brush slots match the machine flange
profile) and lower the machine again (detail 2 fig. 4.14);
To connect it to the support, it is enough to even just briefly actuate brush rotation.
FIGURE N. 4.14
1
2
